Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateFast, Reliable Furnace Repair Across Conway
Furnace repair in Conway typically runs $150 – $700 depending on the part that failed. Most homes we visit off Conway Road and around Lake Conway get a same-day or next-morning appointment, with a written price before any wrench turns. Halden Heating and Air Orlando answers every call with a live person, 24/7, and our technicians arrive with a live arrival time you can track to your door. If your furnace is short-cycling, blowing cold air, or locking out on a cold night, call (850) 695-3178 and we’ll get it diagnosed right.
Conway’s homes have a heating profile all their own. The older concrete block houses near the lakes, the mid-century ranches off Hoffner Avenue, and the newer subdivisions east of Conway Road all behave differently when temperatures dip. We know which failure modes show up where, which means fewer return trips and a repair that actually holds.
Why Halden Heating and Air Orlando Is Conway’s Preferred Furnace Repair Company
We’ve worked in enough Conway homes to know the pattern: galvanized ductwork sweating in summer, rust creeping into the plenum, and blower motors working twice as hard as they should. That local knowledge changes how we diagnose. Instead of swapping a part and hoping, we look at the whole air path, the thermostat calibration, and the electrical load. Then we show you the written price before any work starts.
Andre Fuller leads our team, and the standard he set in 2004 still holds: every repair gets a written guarantee, and if the repair fails during the coverage window, the second visit is free. Not a favor. A contract. That’s the Relay Standard, backed by the Relay Visibility Guarantee on every job. Conway homeowners also get the same thing our customers across Florida get: background-checked, uniformed technicians, a locked price before work begins, and a 365-Day Done Right Promise that covers the full year after we leave.
Scheduling and dispatch run from our Miami-area office, but the crews serving Conway are local, on the road, and ready when your furnace isn’t.
Styles & brands we work with
Heat Pump Repair in Conway
Heat pump repair in Conway is its own discipline because so many homes here run a heat pump as their primary heat source, particularly the 1980s – 2000s wood-frame builds and the newer subdivisions east of Conway Road. When a heat pump loses heating capacity, the usual suspects are a failed reversing valve (the part that switches the system between heating and cooling), a refrigerant leak, or a defrost control board that lost its mind after a lake-effect thunderstorm. Most heat pump repairs in Conway run $150 – $650 on the repair side, depending on the component.
Reversing Valve and Defrost Failures
The reversing valve is the heart of a heat pump’s heating mode. When it sticks, the system blows cold air while the thermostat says heat. We test the valve’s solenoid, check the charge, and verify the defrost sensor before quoting a replacement. It’s a job that should never be guessed at, because the valve itself is not always the problem.
Refrigerant Leak Detection
A slow leak drops heating capacity gradually until one cold night you realize the system has been running constantly for weeks. We use electronic leak detectors and nitrogen pressure testing to find the exact source, then give you a repair price before we open the system. No door-step surprises, because that’s not how we run.
Heating Repair in Conway
Heating repair in Conway often starts with a homeowner saying, “It worked fine last winter.” That’s when we look at the heat exchanger, the ignitor, and the gas valve, because those are the parts that degrade quietly during the long humid off-season. Whether it’s a gas furnace off Lake Margaret Drive or an electric air handler near Barber Park, the repair path starts the same way: a combustion analysis and a static pressure reading. Most heating repairs in Conway fall between $150 and $700.
Heat Exchanger and Ignitor Work
Near the Conway chain of lakes, salt-tinged air accelerates corrosion on heat exchangers. We check for cracks with a combustion analyzer on every repair visit, not just when the customer asks. A cracked heat exchanger is a carbon monoxide risk, and if we find one, we shut the system down and show you the evidence before discussing replacement options. When it’s an ignitor that failed, the repair is usually quick and the part is on the truck.
Gas Valve and Blower Motor Repair
A gas valve that won’t open or a blower motor that hums and stops are two of the most common furnace failures we see in Conway’s older homes. The gas valve controls fuel flow to the burners; the blower motor pushes air through the ductwork. In homes with original undersized ducts, the blower motor works against high static pressure and fails early. We correct the pressure where possible and replace the motor with a unit rated for the actual load.
Trusted Brands We Service in Conway
Our Conway trucks carry parts for Carrier, Trane, and Lennox furnaces, plus Goodman boards and ignitors for the budget-conscious systems common in rental properties around Semoran Boulevard. We stock common capacitors, pressure switches, flame sensors, and ignitors so most repairs happen on the first visit. If your furnace uses another brand, that’s fine too. We service what you have, not what we sell, and we’ll tell you plainly if the system’s age or condition makes repair a bad investment.
Common Furnace Repair Problems We See in Conway Homes
- Corroded heat exchangers near the lakes. Salt-tinged air moving off Lake Conway and Lake Margaret speeds up rust on heat exchanger surfaces. We use a combustion analyzer on every call to check for cracks before recommending any repair.
- Blower motor capacitor failures east of Conway Road. Lake-effect thunderstorms bring power surges that cook capacitors on blower motors. The symptom is a furnace that hums but never starts, and the fix is usually a $20 part and a service call.
- Undersized original ductwork starving new furnaces. Many 1950s – 1970s concrete block homes in Conway still run original duct runs that cannot move enough air for a modern high-efficiency furnace. The result is overheating, short cycling, and cracked heat exchangers.
- Flame sensor buildup from long humid off-seasons. Conway’s humidity leaves a fine oxidation film on flame sensors while furnaces sit idle from March through November. The furnace lights, then shuts down seconds later. We clean the sensor and test ignition five times before we leave.
See the difference
Before
After
Before
After
Before
AfterPricing for Furnace Repair in Conway, FL
Conway’s repair market is consistent across most neighborhoods. Here’s what you can expect based on the work we actually do here:
| Service | Typical Cost in Conway |
|---|---|
| Furnace Repair | $150 – $700 |
| Heat Pump Repair | $150 – $650 |
The spread inside those ranges comes down to parts. A flame sensor cleaning lands at the low end. A blower motor replacement lands at the high end. Before any work starts, you get a written price with the part cost, labor, and guarantee terms spelled out. Estimates are free. Call (850) 695-3178 and we’ll schedule a diagnostic visit that respects your time and your budget.
We Also Serve Cities Near Conway
Our Furnace Repair in Conway team also covers nearby areas including Orlando, Alafaya, Kissimmee, and Apopka. If you live just outside Conway’s boundaries, we still show up with the same written price guarantee and live technician tracking. The dispatch radius is local, and the standards don’t change at the city line.
Serving Conway, FL - Our Local Coverage Area
We’re based in the Conway area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Conway
Conway’s older housing stock, especially the 1950s – 1970s concrete block and masonry homes, was built with ductwork sized for less powerful systems and with far less insulation than newer construction in Baldwin Park. That means your furnace works against higher static pressure and more heat loss, so even a healthy furnace underperforms against a newer home’s system. We measure static pressure and duct leakage on every diagnostic call to separate a furnace problem from a ductwork problem. If the ducts are the bottleneck, fixing the furnace alone won’t fix your comfort, and we’ll tell you that before you spend a dollar.
Yes, more than a homeowner inland should. Proximity to Lake Conway means salt-tinged, humid air moves through your system during the long cooling season, accelerating corrosion on heat exchanger surfaces. A cracked heat exchanger can release carbon monoxide into your living space, which is why we combustion-test every furnace we service near the lakes. If we find a crack, we shut the system down, show you the reading, and walk through your options. This is not a repair to defer.
Thunderstorms that roll east across Conway’s lakes bring power surges that routinely damage furnace capacitors and control boards. Blocks east of Conway Road see the most of this, because the storms gain energy over the water and hit those neighborhoods with abrupt voltage spikes. The result is a furnace blower that hums without starting or a control board that forgets its programming. Installing a surge protector on the furnace circuit is one of the cheapest insurance policies we recommend in this area.
Often, yes. Many Conway homes have original galvanized ductwork that sweats heavily in summer, rusts, and develops hidden leaks that rob your new furnace of the airflow it was designed to move. The furnace itself may be working perfectly while leaking ducts send conditioned air into the attic and pull humid outside air into the return. We inspect the full duct run during a diagnostic visit and show you where the leaks are. Some are worth sealing; some are beyond saving.
Yes, that’s a standard dual-fuel or all-electric setup, and we service both sides of it. The furnace and heat pump share controls, so a problem in one can make the other look broken. We diagnose the full system together, checking the thermostat wiring, the defrost board, and the furnace’s ignition sequence before quoting any repair. Most dual-fuel repairs in Conway fall inside the $150 – $700 furnace range or the $150 – $650 heat pump range, depending on which side failed. Call (850) 695-3178 for an exact quote; estimates are free.
Call Halden Heating and Air Orlando for Furnace Repair in Conway
If your furnace is down, short-cycling, or just not keeping up on cold nights, call (850) 695-3178. A live person answers, not a voicemail tree. We’ll schedule a diagnostic visit, send a background-checked technician with a live arrival time you can track, and hand you a written price before any work begins. Every repair comes with a written guarantee, and if it fails during the coverage window, the second visit is free. That’s how we’ve done it since 2004, and that’s how we do it in Conway.
Written by Andre Fuller, Owner at Halden Heating and Air Orlando, serving Conway, FL since 2004.